Your furnace is a key part of your home. Without one, you wouldn’t be able to stay warm during cold weather. Yet furnaces can have some issues that are more common than others.

Let’s go over these problems and discuss what they might cost to correct so you know before you contact an HVAC technician. Some of the most common furnace repair problems include:

  • Furnace won’t turn on
  • Furnace doesn’t stay lit
  • Furnace won’t blow hot air
  • Furnace won’t turn off

1. My Furnace Will Not Turn On

There are a few reasons why your furnace won’t turn on, so make sure to check all of them.

  • Is your thermostat set correctly? Make sure it’s set to “heat,” “auto” and that your desired temperature is greater than the room’s current temperature. If you have a programmable thermostat, make sure it has fresh batteries.
  • Is the circuit breaker tripped? Your furnace can’t operate if it doesn’t have power. Reset the switch if it’s facing the outside of the electrical panel.
  • Is the furnace switch off? Your furnace has a power switch found on or close to it. Because this switch looks like a light switch, it’s easy to unintentionally turn it off. If it was off, it may take your furnace a few minutes to start.
  • Is the air filter clean? A dusty air filter can cause a lot of issues for your furnace. Get a new one if you can’t see light through it.

Estimated Repair Cost

This problem can be complex, so the estimated cost to repair it varies according to what’s wrong.

2. My Furnace Ignition System Isn’t Working

Your furnace follows a certain sequence when it starts heating your home.

  1. Your thermostat notices the temperature has dropped and tells your furnace to turn on.
  2. The draft inducer fan turns on to bring in fresh air for combustion.
  3. The gas valve opens for the burners, which are lit electronically.
  4. The flame sensor signals to your furnace the burners have been lit.

If something is off during the sequence, your furnace will shut off as a preventive measure.

A couple of possible causes for this issue include:

  • Dirty or malfunctioning flame sensor. If the sensor doesn’t sense a flame, it will turn off your furnace to prevent natural gas from getting into your home. The ignition process corrodes flame sensors as time passes. While cleaning during annual furnace maintenance can help, yours may ultimately need to be taken out and changed.
  • Bad limit switch. This safety feature will turn off your furnace if it senses backdrafting. Backdrafting is hazardous, since carbon monoxide and natural gas can leak into your home. These switches can fail due to age, damage or dust accumulation.
  • Old thermostat. If your thermostat isn’t working correctly, your furnace won’t be able to operate.
  • Dirty air filter. A dirty air filter can reduce airflow and cause your furnace to shut off to prevent overheating. Make sure to replace yours every 30 to 90 days, or anytime you can’t see light through it.

Estimated Repair Cost

These costs are estimates, so it’s important to note yours may fluctuate based on your furnace’s brand and model.

  • Flame sensor: $350–$500
  • Limit switch: $150–$300
  • Thermostat: $150–$350
  • Furnace filter: $10-$30

3. The Furnace Blows Cold Air

In many instances, this problem is tied to a wrong thermostat setting or a dusty air filter that’s restricting airflow. Follow the steps above to fix the issue.

4. The Furnace Can’t Shut Down

If it’s extremely chilly outside or you like your home to be warm, your furnace may be running for a long time.

If this isn’t the case, make sure your thermostat is set correctly and working properly. If your fan setting is at “on,” the blower motor will be running even when the furnace isn’t, so it’ll sound like your furnace is running all the time.

Otherwise, there might be an issue with the blower motor or your ductwork may be losing air, forcing your furnace to run constantly to make up for the air loss.

Estimated Repair Cost

These costs are estimates, so it’s important to note yours may be different based on your furnace’s brand and model.

  • New blower motor: $250–$800
  • Seal ductwork: varies based on square footage

Indoor Comfort Systems HVAC Will Work Hard to Solve Your Furnace Problems Quickly and Affordably

Furnace issues can be an expensive headache, but not when you call Indoor Comfort Systems HVAC. We’ve been providing the quality, affordable furnace repair Croydon homeowners have trusted since year. Contact us at 215-741-5505 to request your free estimate today.